Zanussi ZRT724X User Manual page 35

Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Rear spacers
In the bag with the documentation, there are two spacers
which must be fitted as shown in the figure.
1. Fit the spacers into
the holes. Make sure
that the arrow (A) is
positioned as shown
in the picture.
2. Turn counter-clock-
wise the spacers
through 45° until
they lock into place.
Location
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc. En-
sure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the appliance
should not be positioned below overhanging wall units.
Accurate levelling is ensured by one or more adjustable
feet at the base of the cabinet.
If the cabinet is placed in a corner and the side with the
hinges facing the wall, the distance between the wall and
the cabinet must be at least 10 mm to allow the door to
open enough so that the shelves can be removed.
Door reversibility
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
A
45˚
Levelling
When placing the appli-
ance ensure that it stands
level. This can be achieved
by two adjustable feet at
the bottom in front.
Warning!
min.
100 mm
15 mm 15 mm
It must be possible to disconnect the appliance from the
mains power supply; the plug must therefore be easily ac-
cessible after installation.
To change the opening direction of the door, do these
steps:
35