Operation; Before Use; Clean The Refrigerator; Connect The Power Supply - LG LTNS16121V Owner's Manual

13

OPERATION

OPERATION

Before use

Clean the refrigerator.

Clean your refrigerator thoroughly and wipe off all dust that accumulated
during shipping.

Open refrigerator doors to ventilate the interior.
The inside of the refrigerator may smell like plastic at first. Remove any adhesive tape
Pull-out Tray
from inside the refrigerator and open the refrigerator doors for ventilation.

Connect the power supply.

 Check if the power supply is connected before use.

Wait for the refrigerator to cool.
Allow your refrigerator to run for at least two to three hours before putting food in it.
Check the flow of cold air in the freezer compartment to ensure proper cooling.
The refrigerator makes a loud noise after initial operation.
This is normal. The volume will decrease as the temperature lowers.
CAUTION
 Do not scratch the refrigerator with a sharp object or use a detergent that
contains alcohol, a flammable liquid or an abrasive when removing any tape or
adhesive from the refrigerator.
Do not peel off the model or serial number label or the technical information on
the rear surface of the refrigerator.
NOTE
Remove adhesive residue by wiping it off with your thumb or dish detergent.
Read the "Turning On The Power" section.
CAUTION
Putting food in the refrigerator before it has cooled could cause the food to spoil, or
a bad odor could remain inside the refrigerator.