Table of Contents
Advertisement
Advanced
The Advanced menu screen contains parameters involving your hardware devices. It also provides advanced
settings of the system.
The table below describes the parameters in the screen. Settings in boldface are the default and suggested
parameter settings.
Parameter
Infrared Port (FIR)
Base I/O address/IRQ
DMA
Parallel Port
Mode
Base I/O address
Interrupt
DMA channel
Hyperthreading technology
40
Description
Enables, disables or auto detects the infrared port.
Sets I/O address of the infrared port.
Sets a DMA channel of the infrared port.
Enables, disables or auto detects the parallel port.
Sets the operation mode of the parallel port.
Sets the I/O address of the parallel port. This
parameter is enabled only if Mode is set to ECP or
Bi-directional. This parameter is enabled only if
Mode is set to ECP.
Sets the interrupt request of the parallel port.
Sets a DMA channel for the printer to operate in
ECP mode. This parameter is enabled only if Mode
is set to ECP.
This only support CPU 3.06G or above. BIOS
should automatically hide this selection when
detecting the CPU frequency is below 3.06G or the
CPU does not support Hyperthreading technology.
Even if Hyperthreading technology does not support
on certain system configuration, this value is set
"disabled" as default value.
Options
Enabled
/Disabled/Auto
3F8h/IRQ4; 2F8h/IRQ3; 3E8h/
IRQ4; 2E8h/IRQ3
DMA 1/DMA 3
Enabled
/Disabled/Auto
ECP
, EPP, Output only or Bi-
directional
378
/278/3BC
IRQ7
/IRQ5
DMA3
/DMA1
Enabled/Disabled
Chapter 2
Advertisement
Table of Contents
