Injectors Table - Fisher & Paykel OR24SDMBGX Installation Instructions Manual

b
2
Fig. 2.7
Fig. 2.8
Fig. 2.9a
OR
regulation screw
Fig. 2.9b
14

INJECTORS TABLE

J
BURNERS
Auxiliary (AUX)
Semirapid (SR)
Triple ring (TC)
Oven burner
Broil burner
OPERATIONS TO BE PERFORMED WHEN SUBSTITUTING
THE INJECTORS
Remove the gratings, the burner covers and the knobs;
J
Using a wrench substitute the nozzle injectors "J" (figs. 2.7 - 2.8) with those most
suitable for the kind of gas for which it is to be used.
The burner are conceived in such a way so as not to require the regulation of the
primary air.
SETTING THE BURNER MINIMUM (Valves may vary)
When switching from one type of gas to another, the minimum flow rate must also be
correct: the flame should not go out even when passing suddenly from maximum to
minimum flame.
To regulate the flame follow the instructions below:
– Light the burner
– Set the gas valve to
– Remove the knob
– With a thin screwdriver, turn the regulation screw (Figs. 2.9a and 2.9b) until
adjustment is correct. On some valves, you need to pass by the hole of the
microswitch (Fig. 2.9a) to turn the regulation screw.
For LP/PROPANE gas, tighten the regulation screws completely.
NOMINAL REDUCED LP/PROPANE
POWER POWER
BTU/hr BTU/hr
[1/100 mm]
3500 1000
6000 1500
12000 5000
13000 1500
8500 -
LO
position
NATURAL GAS
11" W.C.P. 4" W.C.P.
Ø injector Ø injector
[1/100 mm]
55 90
72 118
102 170
109 180
88 146