NordicTrack NTTL11512 User Manual page 7

4. Pull the Upright Wire Harness (101) up through a
Handrail Spacer (114). Place the Handrail Spacer on the
right Upright (110) as shown, with the cutout turned to-
ward the treadmill (refer to inset drawing A). Place the
other Handrail Spacer on the left Upright, with the cutout
turned toward the treadmill.
Connect the Upright Wire Harness (101) to the wires ex-
tending from the Console Base (76). Insert the connec-
tors and the Upright Wire Harness into the hole in the
Console Base (refer to inset drawing B).
Set the Handrail (89) on the Handrail Spacers (114),
being careful not to pinch the Upright Wire Harness (101).
5. Insert two Handrail Bolts (111) with Handrail Washers
(112) and Handrail Bushings (113) into the right Upright
(110) and the right Handrail Spacer (114). Turn the
Handrail Bushings so they fit against the Upright with the
thick sides of the Bushings toward the center of the tread-
mill (refer to the inset drawing). Lift the right Handrail (89)
slightly and align the Bolts with the holes in the Handrail.
Loosely thread the Bolts into the Handrail. Do not
tighten the Bolts yet.
Refer to the inset drawing. Remove the Handrail Bolt
(111) used in step 3. Reach inside the left Upright (110)
and spread the tabs on the Grounding Bracket (115) to
allow a Bolt to pass through the Grounding Bracket.
Attach the left Handrail (89) as described above. Make
sure that the Handrail Bushings (113) are turned properly
and that the Bolt goes through the Grounding Bracket.
Tighten all four Handrail Bolts. Press an Upright
Endcap (116) into each Upright.
6. Make sure the Lock Knob Sleeve (106) is pressed into
the left Upright (110).
Make sure that the Lock Pin Collar (105) and the Spring
(104) are on the Lock Pin (102). Insert the Lock Pin into
the Lock Knob Sleeve (106) and the left Upright (110).
Next, press the Lock Knob Spacer (107) onto the left
Upright. Tighten the Lock Knob (108) onto the Lock Pin.
7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet
from damage, place a mat under the treadmill.
4
114
5
114
113
6
108
107
7
A
Cutout
76
114
89
101
B
110
101
76
89
116
110
113
Thick
Side
112
112
111
110
106
104
105
102
110
89
114
115
111