Table of Contents
Advertisement
(11) When completed, "DTCP key Download: OK" will display
in the Terminal window and the SET will reboot
automatically.
[ When process (11) malfunctions, it is not Download.
DTCP Download process start again from (8).
12. Gemstar Operation Confirmation
12-1. Required Test Equipment
(1) PC with Factory Test Program
(2) G-LINK-To-PC Card (Serial GLINK(CN1202))
(3) VBI Inserter (Norpak TES3) - Guide Data Discharge
Equipment
[ If the VBI Inserter(TES3) is not available, a VCR may be
used.
ADJUSTMENT INSTRUCTIONS
12-2. Preparation for Adjustments
(1) When using VBI Inserter(TES3): Signal uses Cable input
and set as below.
(2) When not using VBI Inserter(TES3): VCR uses Cable input
and set as below.
[ Factory Test S/W must be set to "GLinkTo PC Card" ON.
12-3. Adjustment Confirmation Work
(1) Turn on the TV and run Factory Test Program of PC.
[ Program only needs to run once, regardless of set quantity.
(2) Enter the EZ adjust menu by pressing Adjust on the
Service Remote Control (S R/C).
(3) Go to number 1 Gemstar and press Enter.
(4) TV set screen will appear as shown.
(5) Confrim that VBI Test, Glink Test and IR Test PASS from
the screen.
- 15 -
Input Signal
Advertisement
Table of Contents
