Advertisement
Locate the two elevator halves and four of the C.A. hinges. Also
locate two control horns for the elevators. You will also need four
2mm x 16mm bolts to attach the control horns to the elevators. Mark
and drill the holes for the control horn screws on each right and left
elevators. Install the control horns and two C.A.hinges for each elevator.
With the C.A. hinges in place on the elevators use a a small T-pin to
hold the hinge in place when installing onto the stabilizer. Apply a
small amount of thin C.A. to all 4 hinges, remember to apply glue to
the top and bottom of the hinges.
FUSELAGE/RUDDER
VII. Rudder and Tailwheel
Locate the rudder and three CA hinges and the control horn and
two 2mm x 16mm screws. Also locate the tailwheel assembly.
First mark and drill the holes in the bottom of the fuselage for the tail-
wheel bracket. With the tailwheel bracket installed, make a mark on
the rudder so the tailwheel wire can recess on the rudder.
Install the hinges on the rudder, again use T-pins to hold in place.
Apply CA to both sides of the hinges.
Install the tailwheel by using the 3mm x 3mm set screw and the
small wheel collar.
Locate the main landing gear and install them into the slots/holes
in the landing gear blocks. Secure with metal landing gear straps and
screws. Pre-drill the screw holes with a
11
1
⁄
" bit.
1 6
Advertisement
