How To Insert The Batteries - NEC RSH2423S Owner's Manual

(1) A30045A(w fl+) 1994.10.12 12:36 PM '. 3 3 9
About the remote control on the system
Storage and Tips For Using the Remote Control
• The remote control may be stored inside the system
or mounted on a wall.(except 7k, 9k model)

How to Insert the Batteries

Remove the battery cover by pulling
it according to the arrow direction.
Insert new batteries making sure that
the (+) and (-) of battery are installed
correctly.
Reattach the cover by sliding it back
into position.
Inside the Indoor System
Slide Switch Operation (Refer to page 18)
FORCED OPERATION: Used for operation when the remote control cannot be used.
AUTO RESTART: In case the power comes on again after a power failure, the air
conditioner will operate in "Auto Restart Operation" mode. This function automatically
returns the air conditioner to the pervious operating conditions.
REMOTE CONTROL: If you do not want to use Auto Restart Operation
Signal Receptor
Receives the signals from the remote control.
(Signal receiving sound: two short beeps or one long beep.
Operation Indication Lamps
On/Off : Lights up during the system operation.
Sleep Mode : Lights up during Sleep Mode Auto operation.
Timer : Lights up during Timer operation.
Defrost Mode : Lights up during Defrost Mode or Hot Start operation
: Lights up during outdoor unit operation.
OUTDOOR
OUT
UNIT
DOOR
OPERATION
NOTES:
• Use 2 AAA(1.5volt) batteries. Do not use
rechargeable batteries.
• Remove the batteries from the remote
control if the system is not going to be
used for a long time.
(Heat pump model only)
(Cooling model only)
• To operate the room air conditioner, aim the
remote control at the signal receptor.
• The remote control will operate the air
conditioner at a distance of up to 7m.
Signal receptor
Operation indication lamps
9
Slide Switch
FORCED
OPERATION
AUTO
RESTART
REMOTE
CONTROL
Slide Switch