Table of Contents
Advertisement
22
150S4 LCD
Go to cover page
General
DDC Data Re-programming
In case the DDC data memory IC or main EEPROM which storage all
factory settings were replaced due to a defect, the serial numbers have
to be re-programmed.
It is advised to re-soldered DDC IC and main EEPROM from the old
board onto the new board if circuit board have been replaced, in this
case the DDC data does not need to be re-programmed.
Additional information
Additional information about DDC (Display Data Channel) may be
obtained from Video Electronics Standards Association (VESA).
Extended Display Identification Data(EDID) information may be also
obtained from VESA.
DDC EDID structure
For Analog interface: Standard Version 3.0
Structure Version 1.2
For Digital inferface: Standard Version 3.0
Structure Version 1.3
System and equipment requirements
1.
An i486 (or above) personal computer or compatible.
2.
Microsoft operation system Windows 95/98.
3.
EDID301.EXE program (3138 106 10103) as shown in Fig. 1
4.
A/D Alignment kits (3138 106 10079):
inclusion :
a. Alignment box x1 (as Fig. 2)
Fig. 2
Fig. 2
b. Printer cable x1
c. (D-Sub) to (D-Sub) cable x1
Note: The EDID301.EXE (Release Version 1.58 20000818)is a
windows-based program, which cannot be run in MS-DOS.
Fig. 1
Fig. 1
EDID301.EXE
Ver:1.58
Diskette with EDID301.EXE
To Printer
DC 8V~12V
Power
indicator
To Monitor
Video Card
Video Card
A/D Alignment Kits - Analog connection
A/D Alignment Kits - Analog connection
DDC Instructions
Note: The alignment box has already build-in a batteries socket for
using batteries (9V) as power source. Pull out the socket by
remove four screws at the rear of box. Please do not forget that
remove batteries after programming. The energy of batteries can
only drive circuits for a short period of time.
Pin assignment
A. 15-pin D-Sub Connector
1
6
11
Pin No.
Assignment
1
Red video input
Green video input
2
Blue video input
3
Ground
4
5
No Connected
6
Red video ground
Green video ground
7
8
Blue video ground
5
10
15
Pin No.
Assignment
9
+5V
10
Ground
Ground
11
12
Serial data line(SDA)
H.Sync
13
14
V.Sync(VCLK for DDC)
15
Data clock line(SCL)
Hide quick links:
Advertisement
Table of Contents
