Ipv6 Firewall - D-Link DIR-808L User Manual

Section 3 - Configuration
The DIR-808L's IPv6 Firewall feature allows you to configure which kind of IPv6 traffic is allowed to pass through the device.
The IPv6 Firewall functions in a similar way to the IP Filters feature.
Check the box to Enable IPv6 Ingress Filtering.
Enable IPv6
Ingress Filtering:
Enable IPv6 Check the box to enable the IPv6 firewall simple security.
Simple Security:
Configure IPv6 Select an action from the drop-down menu.
Firewall below:
Name: Enter a Name to identify the IPv6 firewall rule.
Use the drop-down menu to select the time Schedule that the
Schedule:
IPv6 Firewall Rule will be enabled on. The schedule may be set to
Always, which will allow this service to always be enabled. You can
create your own times in the Tools > Schedules section.
Use the Interface drop-down menu to specify the interface that
Source:
connects to the source IPv6 addresses of the firewall rule.
IP Address Range: Enter the source IPv6 address range in the adjacent IP Address Range field.
Dest: Use the Interface drop-down menu to specify the interface that connects to the destination IP addresses of the firewall rule.
Select the Protocol of the firewall port (All, TCP, UDP, or ICMP).
Protocol:
Port Range: Enter the first port of the range that will be used for the firewall rule in the first box and enter the last port in the field in the second
box.
D-Link DIR-808L User Manual

IPv6 Firewall

88