Assembly - NordicTrack C2270 NTL12950 User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench
wire cutters . For help identifying the assembly hardware, see the hardware drawings below.
Star Washer (67)–12
Extension Screw
(87)–4
Console Bolt (72)–4
1. Open parts bag A. With the help of a second person,
carefully raise the Upright Base (85) and the Frame (55)
to the position shown.
While the other person holds the Frame (55) and the
Upright Base (85), insert the Base Extension (90) into
the two brackets on the lower end of the Upright Base.
Make sure that the Base Extension is turned so the
Base Pads (81) are beneath it. Note: It may be helpful
to tip the Upright Base forward as you insert the Base
Extension.
3/4" Tek Screw (44)–4
3/4" Screw (7)–2
and your own phillips screwdriver
1" Tek Screw (82)–2
Handrail Bolt (66)–4
Pulse Bar Bolt (127)–4
1
81
6
Short Console
Bolt (112)–2
55
Brackets
85
90
81
and