Storage - Gravely Promaster 34Z Owner's/Operator's Manual

Leveling the Mower Deck
These adjustments should be made on a level surface with the
tires inflated to the correct air pressure.
Level the mower with the slots where 4 chains fasten to the
mower mounting brackets (Figure 20).
1. Shut OFF engine. Engage parking brake. Remove the
ignition key.
2. Raise mower deck to its highest position and place 4.75 in.
(12.1 cm) tall blocks at each rear corner and 4.625 in.
(11.7 cm) tall blocks at each front corner.
3. Lower deck onto the blocks.
4. Loosen the locknuts on the side where the chains are slack
and slide the bolt down the slot until the chains are tight.
5. Tighten the locknuts.
6. Lift mower and remove blocks.
7. Measure height of deck at each side. Measurements must
be within 1/16 in. (1.59 mm) of each other.
8. If measurements are out of range, fix by adjusting chains
on low side of deck.
9. Once deck is level side to side, measure height of deck at
middle of front and on both sides of rear. Front of deck
should be 1/8 in. (3.18 mm) lower than rear.
Right Side View
1
2
3
5
1. Chains
2. Lock Nuts and Slots
3. Mower Mounting
Brackets
Figure 20
1
4
OF3760
4. 4.675 in. (11.7 cm)
Blocks
5. 4.75 in. (12 cm) Blocks
WARNING: AVOID INJURY. Read and understand
entire Safety section before proceeding.
SHORT TERM
NEVER spray unit with high-pressure water or store unit
outdoors.
Inspect unit for visible signs of wear, breakage or damage.
Keep all nuts, bolts and screws properly tightened and know unit
is in safe working condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low pressure water and
lubricate (See Lubricate Unit on page 16 in Maintenance). Touch
up all scratched painted surfaces.
Remove weight from wheels by putting blocks under frame or
axle.
When storing unit for extended periods of time, remove all fuel
from tank and carburetor (run dry). Refer to Engine Manual.
Clean and charge the battery. Charge battery every three to four
weeks when storing unit.
To Take the Unit Out of Storage
2
1. Refer to the engine service manual to prepare the engine
for service.
2. Put fresh, clean fuel in the fuel tank.
3. Begin the maintenance schedule.
4. Charge and install the battery.
3
GB-21

STORAGE