MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the elliptical is used.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power cord is fully plugged in.
If lines appear in the console display, see HOW TO
CHANGE CONSOLE SETTINGS on page 30 and
adjust the contrast level of the display.
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 24.
HOW TO CALIBRATE THE INCLINE SYSTEM
If the incline system is not functioning properly, it may
need to be calibrated. To calibrate the incline system,
press and hold the Calorie Workouts button for several
seconds until the test mode appears in the display.
Next, press the Calorie Workouts button again. Then,
press the Quick Ramp increase or decrease button
to calibrate the incline system. The ramp will move
upward and downward as it calibrates.
When the ramp stops moving, the incline system is
calibrated. Press the Calorie Workouts button repeat-
edly to exit the calibration mode.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first press the power switch to the off posi-
tion and unplug the power cord.
Next, use
a standard
screwdriver to
remove the left
Disc (71).
Note: For
clarity, the left
shield and the
left disc ring are
shown removed
in the drawing
below.
Locate the Reed Switch (38). Turn the Pulley (19) until
a Magnet (43) is aligned with the Reed Switch.
38
43
101
Next, slightly loosen the indicated M4 x 16mm Screw
(101). Then, slide the Reed Switch (38) slightly closer
to or away from the Magnet (43), and retighten the
Screw.
32
71
19