Maintenance; Faults - PlasmaMade GUC 1214 Installation And User Manual

6. Maintenance

Assuming that the PlasmaMade® Airfilter has been installed according to the
instructions, it requires little maintenance. The PlasmaMade® Airfilter is cleaned
automatically as soon as it is put into operation.
If the outside or the sensor becomes dirty with for example dust deposits, these may
be cleaned off simply using a vacuum cleaner.
There are no components that need to be replaced periodically.
You must follow the maintenance instructions of your extractor hood.

7. Faults

Incompetent repairs are dangerous – you run the risk of an electric
shock! If the device is faulty, remove the plug from the socket and
contact customer service.
service@plasmamade.com
Fault Possible cause
Device does not The plug is not inserted in
work. the socket.
Power cut.
Blown fuse.
Red lamp flashing. Overloading of filter.
If the error is not resolved after these operations, please refer to our Helpdesk at:
www.plasmamadeservice.com
9
Solution
Put the plug into the wall socket.
Check whether other kitchen
equipment is working.
Check in the meter cupboard
whether the device's fuse is intact.
Remove power from the filter
temporarily (remove the plug from
the socket briefly) – thereafter the
electronics will reset itself.