FUNAI F42PDME Service Manual page 17

Reference Notes in the Table
Caution:
Refer to "General Caution of Plasma Display" and
"PDP Module Handling" of "IMPORTANT SAFETY
PRECAUTIONS" section not to injure and/or break the
Plasma Display Module.
1. Removal of the Back Cabinet. Remove screws
17(S-1) and 5(S-2).
2. Removal of the Rear Cabinet. Remove screws
22(S-3).
3. Removal of the PCB Shield Plate. Remove screws
12(S-4) and wire assembly CLN8.
4. Removal of the Speaker Cover(s). Remove screws
14(S-5).
5. Removal of the Digital CBA. Disconnect connec-
tors *CN1701, *CN1702, *CN1703, *CN1704, and
*CN1709, and remove screws 4(S-6) and 3(S-7).
6. Removal of the Analog CBA. Disconnect connec-
tors *CN201, *CN203, *CN204, *CN501, *CN502,
*CN701, *CN801, and *CN802, and remove
screws 4(S-8) and 4(S-9).
7. Removal of the Filter CBA. Disconnect connector
*CN801, and remove two connectors, then remove
screws 2(S-10).
8. Removal of the PCB Holder. Remove screws 4(S-
11).
9. Removal of the Front Cabinet Assembly. Remove
screws 14(S-12).
10.Removal of the Brand Plate. Remove screws 2(S-
13).
11.Removal of the Switch CBA. Remove screws 3(S-
14) and disconnect connector *CN751.
12.Removal of the Decoration Panel. Remove screws
20(S-15) and 2(S-16).
13.Removal of the Speaker-1. Remove screws 8(S-
17).
14.Removal of the Speaker-2. Remove screws 8(S-
18).
15.Removal of the Speaker-3. Remove screws 8(S-
19).
16.Removal of the Speaker-4. Remove screws 8(S-
20).
17.Removal of the Speaker Holder(L). Remove
screws 4(S-21).
18.Removal of the Speaker Holder(R). Remove
screws 4(S-22).
19.Removal of the Jack Cover. Remove screws 2(S-
23).
20.Removal of the Filter Holder(L)(s). Remove screws
6(S-24).
21.Removal of the Filter Holder(S)(s). Remove screws
6(S-25).
22.Removal of the Stand Unit. Remove screws 4(S-
26).
23.Removal of the Stand Cover. Remove screws 8(S-
27) and 10(S-28).
24.Removal of the Stand(s). Remove screws 4(S-29)
and 6(S-30).
25.Removal of the Chassis Bracket. Remove screws
8(S-31) and 8(S-32).
26.Removal of the Panel Spacer(s). Remove screws
8(S-33).
27.Removal of the SP Holder Plate(s). Remove
screws 8(S-34).
28.Removal of the Plasma Display Module. Remove
screws 12(S-35).
1-5-2 L0605DC