Chapter 1: Setting Up; Connecting The Stereo - Sony LBT-G200K Operating Instructions Manual

Chapter 1:
Setting
Up

Connecting the Stereo

Inserting the Batteries
Setting the Clock
EN
4

Chapter 1: Setting Up

Connecting the
Stereo
Use the illustrations below to connect your
stereo.
If you want to connect any optional
components to the stereo, see "Connecting
Optional Equipment" in Chapter 6.
STEP 1 Connecting the
Speakers
1 Twist the speaker cable coating and
strip it from the end of the cable.
2 Connect the right speaker to R
connectors and the left speaker to L
connectors with the red cords to + and
the black cords to –.
red
black
STEP 2 Connecting the
Aerial
FM wire aerial*
(supplied)
AM loop aerial (supplied)
*Note: Extend it horizontally
To improve the FM reception
Connect an outdoor FM aerial to the FM
75Ω terminal, using a 75-ohm coaxial cable.
Important
Ground the external aerial from y terminal
against lightning with the screw clamp. To
prevent a gas explosion, do not connect the
ground wire to a gas pipe.
75-ohm coaxial cable
(not supplied)
To improve the AM reception
After you connect the AM aerial, connect a
6- to 15- meter (20- to 50- feet) insulated
wire to the AM terminal. Connect the y
terminal to ground.
Important
Ground the external aerial from y terminal
against lightning with the screw clamp. To
prevent a gas explosion, do not connect the
ground wire to a gas pipe.
L
Insulated wires (not
supplied)
STEP 3
Operating Voltage
Before connecting the power, set
VOLTAGE SELECTOR to the position of
the local power line voltage.
FM 75
AM
screw
clamp
FM 75
AM
Ground wire
screw
clamp
FM 75
AM
Ground wire
Adjusting the
VOLTAGE SELECTOR
220-240V
110-120V