Shark NV360NZ Owner's Manual page 10

Mode 1: Upright Vac - cont.
Cord
Hook
a
b
c
Fig. 6
TO USE:
1 Rotate the cord release to quickly release the power
cord.
2 Secure the power cord in the cord hook (a). (Fig. 6)
= Brush Roll ON
= Bare Floor
= OFF
3 Press the On/Off switch (b) to the "I" position to
vacuum bare floors (straight suction only) or to the
"II" position to engage the motorised floor nozzle (for
vacuuming carpets and rugs). (Fig. 6)
IMPORTANT: The motorised brush indicator light
(c) will illuminate green when motorised floor nozzle
is on, or red if there is a blockage or jam. (Fig. 6)
This feature is designed to protect your Lifetime
Belt that powers your motorised floor nozzle. See
Checking for Blockages on page 19.
9
CUSTOMER CARE - NZ: 0800 002 999
Release suction
for easier push &
pull on high pile
Suction
carpets and
Release Collar
area rugs.
d
4 Gently press the floor nozzle down with your foot
while you grasp the handle and tilt it back towards
you. (Fig. 7)
NOTE: The rotating brush on the motorised floor
nozzle will not spin unless the nozzle is flat against
the floor and the handle is tilted back.
5 Due to the huge suction power of this vacuum,
it may become necessary at times to adjust the
suction release (d) on the handle. (Fig. 6) If the
vacuum seems difficult to push or pull or if it is
lifting up area rugs, adjust the suction release
by rotating the collar 90° anticlockwise to open
the valve. Rotate the collar clockwise to close
the valve when you need high suction and for
vacuuming floors.
6 Empty dust cup after vacuuming and periodically
during use when it appears full. (See "Maintenance"
section for instructions.)
7
When you are finished vacuuming, turn the
vacuum off.
Fig. 7