Section 2:Installation; Removal Of Transportation Screws; Foot Adjustment - Nordmende WM1201WH User Manual

If you plan not to use your machine for a long time, unplug it, shut off
the water supply, and leave the door open in order to keep the inside
of the machine dry and to prevent unpleasant odours in the drum.
As a result of our quality control procedures, a certain amount of
water may remain in your machine from testing. This is not harmful
for your machine and is perfectly normal.
SECTION 2: INSTALLATION
Please pay attention to the following issues before using your washing
machine for the first time.

REMOVAL OF TRANSPORTATION SCREWS

Transportation screws, which are located at the back side of the
machine, must be removed before running the machine.
Loosen the screws by turning them anticlockwise with a suitable
spanner. (DIAGRAM-1)
Pull out the screws and rubber washers .(DIAGRAM-2)
The holes where the transport screws have been removed should be
covered with the plastic transport caps found in the accessories bag.
(DIAGRAM-3)
The transportation screws that have been removed from the machine
must be re-used in any future transporting of the machine.
DIAGRAM-1

FOOT ADJUSTMENT

Do not install your machine on rugs or similar surfaces.
For your machine to work silently and without any vibration, it should
be installed on a flat, non-slippery firm surface. Any suspended floor
must be suitably strengthened.
DIAGRAM-2
3
DIAGRAM-3