Siphon Plug; The Cabinet; The Drum; Limescale Removal - Nordmende WM1201WH User Manual

SIPHON PLUG

Pull out the detergent drawer. Remove the siphon plug and clean the
residues of the softener thoroughly. Fit the cleaned siphon plug in its location.
Check it is fitted properly.

THE CABINET

Clean the exterior surface of the cabinet of your machine with lukewarm water
and a cleaning substance that will not damage the cabinet. After rinsing with
clean water, wipe it with a soft and dry cloth.
WARNING!
If the machine is installed in a location where the ambient temperature can fall
below 0 C, ensure the following procedure is used when it is not in use:
Plug in the machine.
Close the water tap and pull out the water inlet hose or hoses from
the tap.
Place the ends of the water drain and water inlet hoses in a cup on
the ground.
Adjust the program knob to "Draining" program.
The program ready light will be on.
Run the program by pressing the start/pause button.
Unplug your machine when the program is over (program end light is
on).
When you complete these processes, the remaining water inside the machine
will be drained and thus formation of ice in the machine will be prevented.
When you operate your machine again, be sure that the ambient temperature
is above 0 C.

THE DRUM

Do not leave metal items like needles, staples or coins inside your machine.
These pieces cause rust stains in the drum. To eliminate these stains, use a
suitable cleaning substance and follow the recommendations of the cleaning
substance producer. When cleaning rust stains, never use scouring pads or
similar rough objects.

LIMESCALE REMOVAL

If you use the correct amount of the detergent, there will be no need for lime
removal. However, if you wish to remove limescale, use the lime protectors in
the market and pay attention to their warnings.
WARNING!
The lime eliminating substances contain acids and this may cause colour
modifications in your clothes along with an adverse effect on your machine.
Siphon plug
18