Philips DVDR3465H/96 Service Manual page 12

EN 12 3139 785 33120
4.5 Dismantling of the Analogue Board
1) Remove screws from the rear panel 230 to detach
Analogue Board.
2) Service Position of Analogue Board is given in Figure 4-10.
Figure 4-10: Analogue Board Service Position
4.6 Dismantling of the PSU Board
1) Remove 3 screws to loosen the PSU Board 1002 as
shown in Figure 4-11.
Figure 4-11: Remove mounting screw of PSU
2) Service position for PSU Board is given in Figure 4-12.
Insulation
Sheet
Insulation
Sheet
Figure 4-12: PSU Board Service Position
4.7 Dismantling of the HDD
1) Remove 5 screws to loosen the HDD assembly
(HDD1006 + HDD Bracket 185 + Screws 269 + Screws
270 + Suspension Bracket 190 + HDD Damper 191) as
shown in figure 4-13
Figure 4-13: Remove mounting screws for HDD
2) Flip over the HDD Assembly to see the mounting screws
269. Remove the screws 269 to dismantle the HDD 1006
from the HDD Assembly.
Notes: Only the special type of screws as described in
Service Parts List must be used for position number 269.
Using improper screws may damage the mounting holes
on the HDD.