Part List - NordicTrack NCCEL09940 User Manual

ASSEMBLY
Assembly requires two people. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the four
included allen wrenches, assembly requires a phillips screwdriver
wrenches
As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on
pages 24 and 25. The second number refers to the quantity used in assembly. Note: Some small parts may
have been pre-assembled. If a part is not in the parts bag, check to see if it is pre-assembled.
M6 Washer M10 Split
(64)–2
Washer (73)–2
M6 x 16mm Patch
Screw (76)–4
M8 x 44mm Button Screw (84)–8
M8 x 38mm Button Bolt
(105)–2
1. Identify the Front Stabilizer (8). While another person
lifts the front of the Frame (1) and holds the Pedal
Legs (4, 5) in the position shown, attach the Front
Stabilizer to the Frame with four M8 x 44mm Button
Screws (84) and a Support Plate (104).
While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (not shown) to the Frame
in the same way.
, a rubber mallet
7.6mm Spacer
(109)–2
M8 x 54mm Button Screw (83)–4
, and pliers
M4 x 12mm
M8 Jam Nut
Round Head
(86)–6
Screw (96)–1
M8 x 79mm Bolt Set (65)–2
M10 x 108mm Button Screw (70)–2
1
1
104
84
5
, two adjustable
.
M4 x 16mm
Screw (98)–4
M8 x 41mm Button
Bolt (85)–4
4, 5
8
84