2- Brewing Beverages - CBTL 10134 Instruction Book

1
Before First Use: Prime the Pump (continued)
7
The unit will beep twice to indicate the pump is
primed. When all 6 beverage buttons are illuminated
(and not flashing) and the red indicator light is off; the
beverage system is heated and ready for use.
IMPORTANT: If the red indicator light
continues to flash, repeat the priming
procedure. It may take several times to
properly prime the pump.
2
Brewing Beverages
Each coffee and tea capsule features an internal double filtration system to ensure evenly balanced extraction and optimal flavor.
Every serving of espresso, coffee and tea is freshness-sealed to lock in its exquisite taste and aroma.
1
Make sure the water tank is filled, but
does not exceed the MAX water fill line.
3
Make sure the power-supply cord is
plugged into a grounded 3-prong
electrical outlet and the power ON/OFF
button is in the ON position.
8
6.5
8
Empty the cup or mug. Slide out the used capsule drawer
and empty any priming water. Replace the drawer. Place the
empty cup or mug onto the drip plate. When all lights stop
flashing, the beverage system is heated and ready to brew.
2
Check to make sure the capsule drawer is empty.
Raise and lower the capsule lever to eject any used
capsule into the drawer. Pull the used capsule
drawer out, remove capsule (if any) and slide
drawer back into place. Test to make sure drip tray
is properly and securely turned/locked in position at
the appropriate level. Add the drip plate and place
an empty cup or mug under the dispensing spout.
CAUTION: Capsule may be hot.
Use care when handling.
4
All buttons will flash as the unit begins to heat.
When all 6 beverage buttons and the red indicator
light are illuminated (and not flashing); the
beverage system is heated and ready to brew.