9- Draining The Beverage Brewing System; 10- Troubleshooting - CBTL 10134 Instruction Book

9
Draining the Beverage Brewing System
3
Press the top 3 buttons while pressing the
power ON/OFF button to the ON position.
The unit will perform a drainage cycle.
5
Unplug the beverage system.
10
Troubleshooting
I've primed the pump. Priming water has been
dispensed. The red indicator light continues to flash.
The brewed beverage is not hot enough.
The lever cannot be lowered.
The beverage system will not brew.
Beyond the recommended cleaning and maintenance procedures, the CBTL® machine is not user serviceable.
For additional options, please refer to the Limited Warranty.
14
Problem
4
After the beverage system is fully drained,
press the ON/OFF button to the OFF (O) position.
Cause / Solution
It may take several times to properly prime the pump.
Repeat the priming procedure. The unit will beep
➤
twice to indicate the pump is primed. When all 6
beverage buttons are illuminated (and not flashing)
and the red indicator light is off; the beverage system
is heated and ready for use.
Cold cup or mug.
Scale build-up in the beverage system.
Preheat the cup or mug.
➤
Descale the beverage system monthly.
The used capsule drawer is full.
There is a capsule lodged in the capsule compartment.
Slide out the used capsule drawer; dislodge and
➤
remove the used capsule. Replace drawer.
Used capsule in drawer.
Slide out the used capsule drawer; dislodge and
➤
remove the used capsule. Replace drawer.