Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Victory sheriff 22
Summary of Contents for Victory sheriff 22
- Page 1 P a g e VICTORY ‘The Sheriff 22’ All Valve 22 Watt Guitar Head User Guide...
- Page 2 P a g e Thank you, and congratulations on acquiring a Victory Amplification, ‘The Sheriff 22’. This amp is proudly designed and built by our committed team of engineers and craftsmen in the UK. We value simplicity in operation, flexibility in use and absolutely no compromise in tone.
- Page 3 & 80s classic rock and beyond. FOOTSWITCH The Sheriff 22 comes with a single latching footswitch to switch between INPUT I and INPUT II. To enable this function, the Footswitch needs to be plugged into INPUT I and your guitar plugged into INPUT II.
- Page 4 MASTER The MASTER volume control is used to set the stage or overall volume of the Sheriff 22. If this is turned to maximum, then the 22 becomes a non-master volume amplifier where the VOLUME I &...
- Page 5 (i.e. if it’s a 0.5A fuse in the UK @ 230V, it will needs to be a 1A fuse for the USA @ 115V). Always use the correct rating and type of fuse. Victory amplifiers exclusively use UL- approved 20x5mm glass ‘T’ or ‘Timed’ fuses. If you have difficulty acquiring the correct fuses, please contact Victory using service@victoryamps.co.uk.
- Page 6 P a g e Biasing The Sheriff 22 is a fixed Bias amplifier and requires the output valve idle current to be pre-set with a variable resistor. Biasing needs to be done each time the output valves are replaced and should be checked periodically to make sure they are working at their optimum for sound quality &...
- Page 7 The Sheriff 22 has an effects loop, which is a simple, low impedance, series loop. The SEND socket is for connection to the input of effects units. On the Sheriff 22 it is a lower impedance version of the signal that appears at the INPUT. Use the send to connect to floor pedals or rack effects such as Delay, Chorus and Reverb etc.
- Page 8 7.3Kgs Unboxed. 9.5Kgs Boxed Output Power WARNING! The Sheriff 22 has been designed to achieve high sound pressure levels (SPL) so caution is required when playing in full power mode or hearing damage may result. The following measurements were taken at 240V mains input into an 8 Ohm load using a 1 KHz Sine Wave with the output waveforms set just before clipping.
Need help?
Do you have a question about the sheriff 22 and is the answer not in the manual?
Questions and answers