General Operation - Dual DV1014BH Installation & Owner's Manual

DV1014BH

General Operation

Installing the Monitor
Power On/Off
3.5mm A/V Input
Screen Angle
Setting the Clock
9
OPERATION
To install the 10.1" touch screen monitor align the pins on the back
of the monitor with the pins on the front of the unit, and press until it
clicks in place. To remove, press the release tab (next to the SD card
slot) and pull the monitor away from the unit.
Momentarily press the POWER/SOURCE button to turn the unit on.
Hold for 2 seconds to turn the unit off.
Source Press SRC to step through all available input modes: Tuner, Disc
(which includes DVD and CD playback), USB, DualMirror, SD, AV1,
AV2 and Camera. Modes of operation are indicated on the OSD On
Screen Display. Optional device, USB flash drive and SD card must
be connected/inserted to appear in the mode selection string. Modes
of operation can also be accessed from the Main Menu screen (see
below).
Volume Press the VOL+ and VOL- buttons to increase or decrease playback
volume.
Connect external audio/video devices to this 3.5mm auxiliary A/V input.
Menu Press the key area in the top left corner of the touchscreen to access the
main menu screen. From the main menu, view/select any operational
mode (Tuner, Disc, USB, DualMirror, Bluetooth, SD, AV Front, AV Rear or
Camera), enter the Setup menu, control the screen angle or put the unit
in Standby mode.
Press TILT
Standby Press the standby icon (to the right of the TILT icon) to put the unit in
standby mode. Press any spot on the touch screen to exit standby mode.
To set the clock to the current time, press the time display on the Main Menu,
then press the clock icon. Adjust to the desired time, then press the check mark
to save your entry.
p or TILT q to adjust the screen angle up or down.