Table of Contents
Advertisement
Activating the hob
While the cooker hood is searching
for a signal, start activating the hob.
More information about this can be
found in the Operating instructions
for the hob.
When the hob registers that
connection has been established,
confirm activation on the cooker
hood with the run-on option control
515. All indicators will go out.
Confirm activation on the hob.
Con@ctivity 2.0 is now ready to use.
If you do not confirm within 4 minutes,
activation will not take place.
You only need to carry out the
activation procedure once. If the
appliances are disconnected from the
electricity supply, during a power cut
for example, they will still remain
activated.
Activating Con@ctivity 2.0
Activation failed
If connection cannot be established
despite activating the Con@ctivity
function on the cooker hood and
hob, the function must be
deactivated on both appliances and
then the procedure repeated.
Deactivating Con@ctivity 2.0
Deactivation on the cooker hood is
carried out in the same way as
activation, by selecting "" instead
of "".
To deactivate the hob, please refer to
the operating instructions supplied
with it.
Please bear in mind that disabling the
signal will also disable any remote
control function and this will have to
be activated again.
45
Advertisement
Table of Contents
