Installing A Memory Module - Toshiba Satellite L500 User Manual

Installing a memory module

The computer contains slots for two memory modules, one positioned
immediately over the other - the procedures are the same for installing
either module.
1. Shut down the computer - make sure the Power indicator is off (refer to
2. Remove the AC adaptor and all cables and peripherals connected to
3. Turn the computer upside down and remove the memory module cover.
4. Align the notch of the memory module with that of the memory module
■
Downloaded from LpManual.com Manuals
User's Manual
the Turning off the power
required).
the computer.
Figure 8-4 Removing the memory module cover
slot and gently insert the module into the slot at about a 45 degree
angle before holding it down until the latches on either side snap into
place.
Align the grooves along the edges of the memory module with the
locking tabs on the connector and insert the memory module into the
connector firmly. If you find it difficult to install the memory module,
gently prise the locking tabs outwards using the tip of your finger.
Please also ensure that you hold the memory module along its left and
right hand edges - the edges with the grooves in.
section in Chapter 3,
1 1
2
Optional Devices
Getting Started if
2
3 3
8-7