Brew Group - Philips Saeco HD8836 Operating Instructions Manual

• It is recommended to clean the water
• Empty and clean the drip tray daily.
• Also clean the seat of the tray every

Brew Group

• The brew group must be cleaned at
• Turn off the machine by pressing the
• Remove the dregdrawer. Open the
• To remove the brew group, pull it by the
• Wash the brew group with lukewarm
• Thoroughly wash and dry all the parts
• Thoroughly clean the inside of the
Downloaded from CoffeeMachineManual.com Manuals
tank daily.
- Remove the small white fi lter in the
water tank and wash it under running
drinking water.
- Reposition the small white fi lter in
its housing by gently pressing and
turning it at the same time.
- Fill the water tank with fresh drinking
water.
Perform this operation also when the
fl oat is raised.
week through the openings on the
bottom of the machine.
least once a week.
ON/OFF button and remove the plug
from the socket.
service door.
handle and press the «PUSH» button.
The brew group must be washed only
with lukewarm water, no detergent/
soap is necessary.
water and carefully clean the upper
fi lter.
of the brew group.
machine.
• Make sure that the brew group is in
rest position. The two references must
match.
• The lever on the rear part of the brew
group must be in contact with the base.
Press the "PUSH" button to make sure
that the brew group is in the correct
position.
Lubricate the brew group af-
ter approximately 500 brew-
ing cycles. The brew group lubricant
may be purchased at authorized
service centers.
• Lubricate the brew group guides using
the supplied lubricant only.
• Apply the lubricant evenly on both side
guides.
• Insert the brew group in its seat until it
locks into place WITHOUT pressing the
"PUSH" button.
• Insert the dregdrawer. Close the service
door.
• 17 •