Siemens TE603 Instruction Manual page 18

en
The setting is then saved.
Languages
Setting up the language to be used for
display texts.
● Use I to choose the desired
language and touch B to confirm
your choice.
Water hardness
Set this to the hardness of the local water
supply.
Level 1, 2, 3, 4 or Softening system can be
selected. The preset level of water hard-
ness is level 4.
● Use I to choose the desired water
hardness and touch B to confirm
your choice.
F It is important to set the water hard-
ness correctly, so that the appliance
indicates accurately when the
d escaling programme should be run.
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier. If a water softening
system is installed in the house, please
select the Softening system setting.
● Briefly dip the test strip in the water and
check the result after one minute.
Level Water hardness
German (°dH) French (°fH)
1 1-7
2 8-14
3 15-21
4 22-30
Automatic shut-down
Setting how long the appliance should wait
after the last drink was prepared before it
automatically switches itself off.
You can specify values from 15 minutes to
8 hours. The factory setting is 30 minutes.
● Use I to choose the desired interval
and touch B to confirm your choice.
14
1-13
14-25
26-38
39-54
Coffee temperature
Specifying the temperature for coffee drinks
and hot water.
You can choose normal, high, or max.
The setting applies to all types of drink
preparation.
● Use I to choose the desired
temperature level and touch B to
confirm your choice.
Water filter
Specifying whether a water filter should be
activated or whether no filter is used.
You can choose Activate new filter or No
filter.
F Using a water filter can prevent the
build-up of limescale.
Water filters are available from retail outlets
or from customer services (see the section
"Accessories").
F Important: Before you can use a
new water filter it will need to be
rinsed.
● Use the measuring spoon 8 to press the
water filter firmly into the water tank 5.
● Fill the water tank with water up to the
"max" mark.
● Connect the milk tube 4c to the milk
system 4b and the suction pipe 4d.
● Insert the end of the suction pipe 4d into
the drip plate 17b.
● Touch A and use I to select
Water filter.
● Touch B and use I to select
Activate new filter.
● Empty the drip tray and re-insert.
● Touch B to confirm.
Water will now flow through the filter to
rinse it.
● Then empty the drip tray and re-insert.