Checks And Adjustments - Dolmar TM-102.16 Operator's Manual

38
EN

6.3 CHECKS AND ADJUSTMENTS

6.3.1 C
UTTING DECK ALIGNMENT
The cutting deck should be properly set to obtain
a good cut.
NOTE
from cutting, the front part should always be 5 -
6 mm lower than the rear.
– Put the machine onto a flat surface and check
the tyre pressures;
– put 26 mm blocks (1) under the front edge of the
deck and 32 mm blocks (2) under the rear edge,
and thenput the lifting lever into position «1»;
– loosen the nuts (3), the screws (5) and the lock-
nuts (4 – 6) on both the right and left side, so
that the deck is resting firmly on the blocks;
– push the two connecting rods (7) to the back
and screw down the two nuts (3) on each rod
until the front part of the deck just begins to rise
both at the right and the left, and then tighten
the relevant locknuts (4);
– turn both the rear screws (5) until the rear of the
deck begins to rise both at the right and the left,
and then tighten the relevant locknuts (6).
In case of any doubts, do not hesitate to contact your Retailer.
6.3.2 A
DJUSTMENT OF THE SPRING OF THE PAWL FOR
HOOKING THE GRASS
If the grass-catcher tends to jump about and to open
up when going over rough ground, or if it has difficulty
in hooking back on after being emptied, the tension of
the spring will need to be adjusted (1).
Change the hooking point by using one of the holes (2)
until the required result is achieved.
For achieving good results
-
CATCHER
MAINTENANCE
1 = 26 mm
2 = 32 mm
4 3
5
6
1
2
7