Table of Contents
Related Manuals for hestan HFT Series
Summary of Contents for hestan HFT Series
- Page 1 Owner’s Guide Installation & Operation French Top HFT Series Hestan Commercial Corporation 3375 E. La Palma Ave Anaheim, CA 92806 (888) 905-7463 RETAIN THIS MANUAL FOR FUTURE REFERENCE P/N 002131 REV 1 ©2015 Hestan Commercial Corporation...
- Page 2 IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE CAN CAUSE PROPERTY DAMAGE, INJURY OR DEATH. READ INSTALLATION, OPERATING MAINTENANCE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING OR SERVICING THIS EQUIPMENT. IN THE EVENT OF A POWER FAILURE, DO NOT ATTEMPT TO OPERATE THIS DEVICE. ©2015 Hestan Commercial Corporation...
-
Page 3: Table Of Contents
Electrical Supply .....................8 Model / Serial / Rating Plate Location ..............8 Section 2: Operating Instructions ................Lighting and Shutdown Instructions ..............9 Section 3: Cleaning and Maintenance ..............Gas-Fired Appliances ..................10 ....................Service Troubleshooting Guide .................. 11 ©2015 Hestan Commercial Corporation... -
Page 4: Installation
4” legs are mounted using four hex-head bolts per leg and each leg is adjustable simply by turning the inner cylinder leg, clockwise to lower and counter-clockwise to elevate. NOTE: A carpenter’s level can be used on the plate shelf for left to right leveling. ©2015 Hestan Commercial Corporation... -
Page 5: Riser Installation
National Fire Protection Association, on their web site: http://www.nfpa.org/ Canada 1) Local Codes 2) CSA B149.1 Natural Gas and Propane Installation Code. 3) CSA C22.1 Canadian Electrical Code 4) CSA C22.2 Canadian Electrical Code Canadian codes can be found on the CSA website: http://www.csa.ca ©2015 Hestan Commercial Corporation... -
Page 6: Gas Supply
.18 psig (1.25kpa) coming out of the regulator. For liquid propane gas pressure coming into the regulator should be 11” WC or .4 psig (2.75kpa) and 10” WC .36 psig (2.5kpa) coming out of the regulator. ©2015 Hestan Commercial Corporation... -
Page 7: Gas Pressure Regulator
All gas burners and pilots need sufficient air to operate. Large objects should not be placed in front of the appliance(s) that would obstruct the flow of air into the front. NOTICE: In the Commonwealth of Massachusetts all gas appliances vented by either mechanical systems or ventilation hoods shall comply with 248 CMR interlocking requirements. ©2015 Hestan Commercial Corporation... -
Page 8: Electrical Supply
If the receptacle is not the proper grounding type, contact an electrician. Do not remove the grounding prong from this plug. Model / Serial / Rating Plate Locations Range tops Rating plate will be located above the front panel ©2015 Hestan Commercial Corporation... -
Page 9: Operating Instructions
4) Re-install center ring. For daily shutoff: Turn burner valve knob(s) to the “OFF” position, pilot(s) will remain on. A 5 minute complete shutoff period is required before the appliance is re-lighted ©2015 Hestan Commercial Corporation... -
Page 10: Cleaning And Maintenance
Heat tint can be removed by scouring with stainless steel wool or scouring powder. Rub in direction of polished lines. ©2015 Hestan Commercial Corporation... -
Page 11: Service
Pilot not lit Burner not working well/lazy or yellow flame Gas pressure incorrect / incorrect regulator Orifice sized incorrectly Burner ports are obstructed or dirty Poor combustion, air fuel mixture not adjusted properly ©2015 Hestan Commercial Corporation...