Switch The Device On; Charge The Battery - Nokia NSERIES N95-4 Get Started

Switch the device on

1 Press and hold the power key.
2 If the device asks for a (U)PIN code
or lock code, enter it, and press the
left selection key. The factory
setting for the lock code is 12345.
Your device has internal antennas.
Note: As with any radio transmitting device, avoid
touching an antenna unnecessarily when the
antenna is in use. For example, avoid touching the
cellular antenna during a phone call. Contact with
a transmitting or receiving antenna affects the
quality of the radio communication, may cause the
device to operate at a higher power level than
otherwise needed, and may reduce the battery life.
1 Cellular antenna
2 Bluetooth technology/
wireless LAN antenna
3 GPS receiver
6

Charge the battery

1 Connect a compatible
charger to a wall outlet.
2 Connect the power cord
to the device. If the
battery is completely
discharged, it may take a
while before the charging
indicator starts scrolling.
3 When the battery is fully
charged, the charging indicator stops scrolling.
Disconnect the charger from the device, then
from the wall outlet.
Tip: Disconnect the charger from the wall outlet
when the charger is not in use. A charger that is
connected to the outlet consumes power even when
it is not connected to the device.