Setting Up The Universal Remote Control - Philips SRP5004 User Manual

2.3
This is only necessary if your device does not respond to the
SRP5004. If that is the case, the SRP5004 does not recognize
the brand and / or model of your device and you need to set
up the remote control to do so.
The example below instructs you how to do this for your TV.
You can repeat the same steps for other devices (STB, DVD
player/recorder and VCR) which you want to operate, using
the SRP5004.
The remote control can be set up to operate any 4 of the
following devices:
Device name
TV
STB
DVD
VCR
Example: setting up the universal remote control to
operate your TV:
1
2
SRP5004_86_Manual_Def.indd 5

Setting up the universal remote control

Turn ON the TV manually or use the original remote
control for this. Tune to channel 1.
Press and hold the
device selection key
for 5 seconds until the red
Setup LED lights up.
• T he remote control is
now in setup mode.
Description
T raditional TV, flat screen TV and
projection TV, TV part of TV / VCR, TV /
VCR / DVD and TV / DVD combos
Cable box, satellite receiver, Digital
Video Broadcasting Terrestrial device
(DVB-T), Internet Protocol TV
(IPTV), Free To Air TV, High Definition
Television decoder (HDTV)
DVD player / recorder (DVDR), DVD /
Hard Disk Drive combination (DVDR-
HDD), Blu-Ray player, High Definition
DVD player (HD-DVD), DVD part of
TV / DVD, TV / VCR / DVD and VCR /
DVD combos
Video cassette player / recorder, VCR
part of TV / VCR, TV / VCR / DVD and
VCR / DVD combos
5 sec.
EN
5
01-06-09 12:33