Route Guidance; Retrieve Position Information; Trip Meter - Nokia N82 User Manual

made, it may be possible to continue calculating the
coordinates of your location with three satellites.
However, the accuracy is generally better when
more satellites are found.

Route guidance

Press , and select
data > Navigation.
Start the route guidance outdoors. If started
indoors, the GPS receiver may not receive the
necessary information from the satellites.
Route guidance uses a rotating compass on the
device display. A red ball shows the direction to the
destination, and the approximate distance to it is
shown inside the compass ring.
Route guidance is designed to show the straightest
route and the shortest distance to the destination,
measured in a straight line. Any obstacles on the
route, such as buildings and natural obstacles, are
ignored. Differences in altitude are not taken into
account when calculating the distance. Route
guidance is active only when you move.
To set your trip destination, select
destination and a landmark as the destination, or
enter the latitude and longitude coordinates. Select
Stop navigation to clear the destination set for
your trip.
60
Tools Connectivity
> >
Options
>

Retrieve position information

Press , and select
data > Position.
In the position view, you can view the position
information of your current location. An estimate of
the accuracy of the location is displayed.
GPS
To save your current location as a landmark, select
Options Save
>
locations with more information, and they can be
used in other compatible applications and
transferred between compatible devices.

Trip meter

Press , and select
data Trip distance.
>
Select Options
>
calculation, and Stop
calculated values remain on the display. Use this
feature outdoors to receive a better GPS signal.
Select Reset to set the trip distance and time and
average and maximum speeds to zero, and to start
a new calculation. Select
Set
odometer and total time to zero.
The trip meter has limited accuracy, and rounding
errors may occur. Accuracy can also be affected by
availability and quality of GPS signals.
Tools Connectivity
>
position. Landmarks are saved
Tools Connectivity
>
Start to activate trip distance
to deactivate it. The
Restart to set the
GPS
>
GPS
>