7. Remove the screws (×7
8. Remove the molding props (×13
9. Remove the P-Board.
Note:
When assembling the P-Board, the position of each hole of
the insulation sheets (A and B) is set to the position of each
hole of the P-Board, then assemble them. (
cate setting positions.)
).
).
marks indi-
7.5.
Remove
cover
1. Remove the screws (×4
2. Remove the Rear Terminal cover.
7.6.
Remove the A-Board unit
1. Unlock the cable clampers to free the cable.
2. Disconnect the connectors (A1, A3, A5, A6, A7, A11, A12,
A30, A51 and A52).
3. Remove the screws (×4
unit.
7.7.
Remove the A-Board
1. Remove the A-Board unit. (See section 7.6.)
2. Remove the screws (×8
18
the
Rear
Terminal
, ×2
).
) and remove the A-Board
) and remove the A-Board.