Wlan Internet Access Points - Nokia E72 User Manual

Authentication
•
password encrypted or
encrypted when possible.
Homepage — Depending on the access point type you
•
are setting up, enter the web address or the address of
the multimedia message center.
Use access point
•
the device to ask for confirmation before the
connection using this access point is created, or
Automatically
destination using this access point automatically.
Select Options
>
following:
Network type
•
transfer data to and from your device. The other
settings depend on the selected network type.
Phone IP address
•
of your device.
DNS addresses
•
and secondary DNS servers, if required by your service
provider. To obtain these addresses, contact your
internet service provider.
Proxy server address
•
server.
Proxy port number
•
proxy server.

WLAN internet access points

Select Menu Ctrl. panel
>
Destinations Access
>
on the display. Or, open one of the access point groups,
select an access point marked with
124
Options > Edit.
— Select Secure to always send your
Normal to send your password
— Select After confirmation
to set the device to connect to the
Advanced settings and from the
— Select the internet protocol type to
(for IPv4 only) — Enter the IP address
— Enter the IP addresses of the primary
— Enter the address of the proxy
— Enter the port number of the
Settings and Connection
>
point, and follow the instructions
, and select
Use the instructions provided by your service provider to
edit the following:
WLAN network name
•
Search for networks. If you select an existing network,
WLAN network mode
determined by the settings of its access point device.
to set
Network status
•
is displayed.
WLAN network mode
•
ad hoc network, and to allow devices to send and
receive data directly; a WLAN access point device is not
needed. In an ad hoc network, all devices must use the
same WLAN network name.
WLAN security mode
•
WEP, 802.1x, or WPA/WPA2. (802.1x and WPA/WPA2
are not available for ad hoc networks.) If you select
Open network, no encryption is used. The WEP, 802.1x,
and WPA functions can be used only if the network
supports them.
Use access point
•
the device to ask for confirmation before the
connection using this access point is created or
Automatically
destination using this access point automatically.
To enter the settings for the selected security mode, select
WLAN security
Advanced WLAN settings
Select Options
>
following:
IPv4 settings
•
the subnet IP address, the default gateway, and the IP
addresses of the primary and secondary DNS servers.
— Select Enter manually
and WLAN security mode
— Define whether the network name
— Select Ad-hoc
— Select the encryption used:
— Select After confirmation
to set the device to connect to the
settings.
Advanced settings and from the
>
— Enter the IP address of your device,
or
are
to create an
to set