Landmarks; Gps Data - Nokia E72 User Manual

When you receive a position request, the service that is
making the request is displayed. Select
your position information to be sent or
request.

Landmarks

With Landmarks, you can save the position information of
specific locations in your device. You can sort the saved
locations into different categories, such as business, and
add other information to them, such as addresses. You can
use your saved landmarks in compatible applications, such
as GPS data.
Select Menu Applications
>
The coordinates in the GPS are expressed using the
international WGS-84 coordinate system.
Select Options and from the following:
New landmark
•
positioning request for your current location, select
Current position. To select the location from the map,
select Select from
information manually, select
Edit — Edit or add information to a saved landmark
•
(for example, a street address).
Add to category
•
Landmarks. Select each category to which you want to
add the landmark.
Send — Send one or several landmarks to a compatible
•
device. Your received landmarks are placed in the Inbox
folder in Messaging.
You can sort your landmarks into preset categories, and
74
create new categories. To edit and create new landmark
Accept
Reject
> Landmarks.
— Create a new landmark. To make a
map. To enter the position
Enter manually.
— Add a landmark to a category in
categories, open the categories tab, and select
to allow Edit categories.
to deny the

GPS data

Route guidance
Select Menu
Navigation.
Start the route guidance outdoors. If started indoors, the
GPS receiver may not receive the necessary information
from the satellites.
Route guidance uses a rotating compass on the device
display. A red ball shows the direction to the destination,
and the approximate distance to it is shown inside the
compass ring.
Route guidance is designed to show the straightest route
and the shortest distance to the destination, measured in
a straight line. Any obstacles on the route, such as
buildings and natural obstacles, are ignored. Differences
in altitude are not taken into account when calculating the
distance. Route guidance is active only when you move.
To set your trip destination, select
destination
the latitude and longitude coordinates.
To clear the destination set for your trip, select
navigation.
Trip meter
Select Menu
distance.
Applications GPS data
> >
Options
and a landmark as the destination, or enter
Applications GPS data
> >
Options
>
and
Set
>
Stop
and Trip