Wpa Security Settings - Nokia E72 User Manual

802.1x authenticates and authorizes devices to access a
wireless network, and prevents access if the authorization
process fails.
Select WLAN security settings
WPA/WPA2 — Select
•
Protocol) or Pre-shared key
device identification).
EAP plug-in settings
•
EAP, select which EAP plug-ins defined in your device to
use with the access point.
Pre-shared key — If you selected
•
shared key, enter the shared private key that identifies
your device to the WLAN to which you connect.

WPA security settings

Select WPA/WPA2 as the WLAN security mode.
Select WLAN security settings
WPA/WPA2 — Select
•
Protocol) or Pre-shared key
device identification).
EAP plug-in settings
•
EAP, select which EAP plug-ins defined in your device to
use with the access point.
Pre-shared key — If you select
•
shared key, enter the shared private key that identifies
your device to the WLAN to which you connect.
WPA2 only mode — To allow both TKIP and AES
•
(Advanced Encryption Standard) encryption, select Off.
To allow AES only, select
and from the following:
EAP (Extensible Authentication
(a secret key used for
— If you selected WPA/WPA2
WPA/WPA2
and from the following:
EAP (Extensible Authentication
(a secret key used for
— If you select WPA/WPA2
WPA/WPA2
>
On
Wireless LAN plugins
Select Menu
>
Destinations, and an access point group.
The extensible authentication protocol (EAP) plug-ins are
used in wireless networks to authenticate wireless devices
and authentication servers, and the different EAP plug-ins
make possible the use of various EAP methods (network
>
service).
You can view the EAP plug-ins currently installed in your
device (network service).
Pre-
>
EAP plug-ins
1. To define the EAP plug-in settings, select
New access point
WLAN as a data bearer.
2. Select 802.1x
3. Select WLAN security settings
EAP EAP plug-in
>
Use EAP plug-ins
To use an EAP plug-in when you connect to a WLAN using
>
the access point, select the desired plug-in and
Enable. The EAP plug-ins enabled for use with this access
point have a check mark next to them. To not use a plug-
Pre-
in, select Options
To edit the EAP plug-in settings, select
To change the priority of the EAP plug-in settings, select
Options Raise priority
>
before other plug-ins when connecting to the network
with the access point,
Ctrl. panel Settings and
>
and define an access point that uses
or WPA/WPA2 as the security mode.
WPA/WPA2
>
settings.
> Disable.
Options
to attempt to use the plug-in
orOptions Lower priority
>
Connection
>
Options
>
>
Options
>
> Edit.
to use
127