Nokia E61 User Manual page 60

3. Define the following settings.
Connection name — Enter a descriptive name for
•
the connection.
Data bearer — Select Packet
•
Access point name — Enter the name for the
•
access point. The name is usually provided by
your service provider or network operator.
User name — Enter your user name if required
•
by the service provider. User names are often
case-sensitive and provided by your service
provider.
Prompt password — Select
•
password each time you log into a server or
to save the password in your device memory and
automate the login.
Password — Enter your password if required by
•
the service provider. The password is often case-
sensitive provided by the service provider.
Authentication — Select
•
your password encrypted or
password encrypted when possible.
Homepage — Enter the Web address of the page
•
you want to display as a home page when you
use this access point.
4. After defining the settings, select
Advanced settings to define the advanced settings
or Back to save the settings and exit.
For information on the advanced settings, see the
extended user guide on the Web.
60
Set up an Internet access point for
wireless LAN
data.
1. Select Menu
Access
2. Select Options
existing access point as a basis for the new one,
select Use existing
access point, select
3. Define the following settings.
Yes to enter your
Connection name
•
No
the connection.
Data bearer
•
WLAN netw. name
•
identifies the specific wireless LAN, select
manually. To select the network from the
wireless LANs in range, select
Secure to always send
Network status
•
Normal to send your
you are connecting to is hidden, or
not hidden.
WLAN netw. mode
•
Infrastructure, devices can communicate with
each other and with wired LAN devices through
Options a wireless LAN access point. If you select Ad-hoc,
>
devices can send and receive data directly with
each other, and no wireless LAN access point is
needed.
WLAN security mode
•
same security mode that is used in the wireless
LAN access point. If you select WEP (wired
equivalent privacy), 802.1x, or WPA (Wi-Fi
protected access), you must also configure the
relevant additional settings. See the extended
Tools Settings Connection
> > >
points.
New access point. To use an
>
settings. To start with an empty
Use default settings.
— Enter a descriptive name for
— Select Wireless LAN.
— To enter the name that
Search for netw..
— Select Hidden if the network
Public
— If you select
— You must select the
>
Enter
if it is