Bosch IXO Original Instructions Manual page 30

OBJ_BUCH-826-007.book Page 30 Tuesday, July 9, 2013 1:14 PM
30 | English
Assembly
 Before any work on the machine (e. g., maintenance, tool change,
etc.) as well as during transport and storage, set the rotational direc-
tion switch to the centre position. Unintentional actuation of the On/Off
switch can lead to injuries.
Battery Charging (see figure A)
 Do not use other battery chargers. The supplied battery charger is de-
signed for the Lithium-Ion battery in your machine.
 Observe the mains voltage! The voltage of the power supply must corre-
spond with the data given on the nameplate of the battery charger. Bat-
tery chargers marked with 230 V can also be operated with 220 V.
Note: The battery is supplied partially charged. To ensure full capacity of the
battery, completely charge the battery in the battery charger before using
your power tool for the first time.
The lithium ion battery can be charged at any time without reducing its ser-
vice life. Interrupting the charging procedure does not damage the battery.
The Lithium-Ion battery is protected against deep discharging. When the bat-
tery is discharged, the machine is automatically switched off by a protective
circuit: The inserted tool no longer moves and a slight whistling noise can be
heard.
 Do not continue to press the On/Off switch after the machine has
been automatically switched off. The battery can be damaged.
When the battery charge-control indicator 5 lights up red while the On/Off
switch 8 is depressed half way, then the battery has less than 30% of its ca-
pacity and should be charged.
The charging procedure starts as soon as the main plug of the battery charger
is inserted into the socket and the cordless screwdriver is afterwards placed
on the battery charger 12.
The battery charge-control indicator 5 indicates the charging progress. The
indicator lights up green during the charging process. When the battery
charge-control indicator 5 is no longer lit, the battery is fully charged.
During the charging procedure, the handle of the machine warms up. This is
normal.
1 609 92A 0AD | (9.7.13) Bosch Power Tools