Samsung WF350AN Series User Manual page 16

setting up your washer
3. Check the inlet hose to ensure a washer is inside each fi ll hose.
Thread the inlet hoses to the HOT and COLD faucet
connections.
On the other end of the hose, check for one rubber washer per
hose and install each fi ll hose to the water valve. Make sure the
hose with the Hot printed line is attached to the HOT faucet.
Tighten by hand until snug, then two-thirds of a turn with pliers.
For correct water use, connect both HOT and COLD water
valves. If either or both are not connected, an "nF" (no fi ll) error
can occur.
4. Turn on the HOT and COLD water supply and check all
connections at the water valve and the faucet for leaks.
5. Plug the power cord into a 3-prong, well grounded 120
volt 60 Hz approved electrical outlet protected by a 15-
amp fuse or comparable circuit breaker.
Your washer is grounded through the third prong of the
power cord when plugged into a three-prong grounded
receptacle.
6. Slide your washer into position.
7. Level your washer by turning the leveling legs in or out as
necessary by hand or by using the wrench included with
your washer.
When your washer is level, tighten the locking nuts using
the wrench or (-) fl athead screwdriver.
Your washer must be leveled on all four sides. A
carpenter's level should be used on all four corners of
your washer. It's the best to recheck after the fi rst dozen
washes.
Avoid damage to the legs. Do not move
the washer unless the locking-nuts are
fastened to the bottom of the washer.
16_ setting up your washer
WF350AN-02833B-07_EN_20120712.indd Sec3:16 WF350AN-02833B-07_EN_20120712.indd Sec3:16
Cold Cold Hot Hot
Cold printed Cold printed Hot printed Hot printed
Locking Locking
Nut Nut
Levelling Levelling
Leg Leg
2012-07-13 2012-07-13 10:36:40 10:36:40