Completing The Installation - Haier HWE15XCRHWE18VCR User & Care Manual

COMPLETING THE INSTALLATION

COMPLETE THE INSTALLATION
1. Uncoil the included foam seal. (See Fig.15)
2. Insert the foam seal behind the top of the lower window sash and
against the glass of the upper window. (See Fig.16)
3. Place the window lock bracket as shown. Use
a 1⁄8" drill bit to drill a starter hole through the
hole in the window lock bracket and into the
upper window sill.(See Fig.17)
4. Attach the window lock bracket to the upper
window with one (1) 1" wood screw to secure
the window in place. (See Fig.17)
INSTALLING THE CHASSIS TO THE
CABINET
(See Fig.18)
When moving or lifting the air conditioner
chassis, use two or more people. Wear gloves when
handling the air conditioner to protect against possible
sharp edges and metal fins.
1. Pick up the chassis carefully and evenly.
2. Slide the chassis into the cabinet. (See Fig.18)
3. Reinstall the front panel.
4. Secure the front panel to the chassis using the screws
removed at the start of the installation. (A) (See Fig.19)
5. Reinstall two of the screws removed from the cabinet at the start of the installation. (B) (See
Fig.19)
NOTE: Two rear screws (B) not required.
6. Press RESET on the power supply cord. A green light will come on. See "Electrical
Requirements."
Fig. 18
Top of lower
window sash
Fig. 17
Window Lock
Fig. 19
HOW TO INSTALL
Fig. 15
Foam seal
Bracket
A
B
Fig. 16
PAGE 15