Eliminating Minor Faults Yourself - Bosch KGN series Instructions For Use Manual

en

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
The light does not function.
Fig. !/12
Display indicates "E..".
Controls have reduced
luminosity.
Displays do not illuminate.
The temperature in
the freezer compartment is
too warm.
40
Possible cause
Light switch is sticking.
The light is defective.
Electronics have detected a
fault.
When the appliance is not
used for some time,
the display on the fascia
switches to energy saving
mode.
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Appliance opened
frequently.
The ventilation openings
have been covered.
Large quantities of fresh
food are being frozen.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
Check whether the light switch can move. Fig.
!/10
See chapter "Light".
Call customer service.
As soon as the appliance is again used, e.g.
the door is opened, the display switches back
to normal illumination.
Connect mains plug. Check whether the power
is on, check the fuses.
Do not open the appliance unnecessarily.
Remove obstacles.
Do not exceed max. freezing capacity.