Tools Required - DeWalt DW7440RS Instruction Manual

Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
these symbols.
DANGER: Indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or serious
injury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury.
NOTICE: indicates a practice not related to personal injury
which, if not avoided, may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS
OR ANY D WALT TOOL, CALL US TOLL FREE AT:
E
1-800-4-D WALT (1-800-433-9258)
E
DW7440RS Rolling Table Saw Stand
with Folding Legs
WARNING: For your own safety, read the table saw instruction
manual before using any accessory. Failure to heed these warnings
may result in personal injury and serious damage to the table saw
and the accessory. When servicing this tool, use only identical
replacement parts.
This stand is designed for use with table saws only. The DW7440RS
stand has been evaluated by UL for use with the DW744, DW744X
and the DW745 table saws. This stand can be used with other table
saw models but these models have not been evaluated for use with
this stand by UL. If you experience a problem with your D
purchase, please call 1-800-4-D

Tools Required

Phillips screwdriver
Socket or wrench set
Contents
Stand
Mounting brackets (2)
Wheels (2)
Rubber bumpers (2)
Washers (4)
Kickstand assembly
Tube plugs (2)
Saw mounting hardware: hex head bolts (4), washers (8),
nuts (4), lock washers (4)
General Safety Instructions for Table
Saw Accessories
WARNING: To reduce the risk of personal injury:
• ALWAYS use eye protection. All users and bystanders must
wear eye protection that conforms to ANSI Z87.1.
• Ensure all stand fasteners are securely fastened and that all
stand mechanisms are in proper working order before operating
the table saw.
• DO NOT exceed the weight this stand can hold. The DW7440RS
table saw stand is designed to support 150 lbs. (68 kgs.) safely
in a work environment. It is unsafe to climb, sit or stand on the
stand.
2
WALT
E
WALT (1-800-433-9258).
E
Carriage head bolts (2)
M8 lock nuts (4)
Rear axle
M4 screws (2)
M4 lock nuts (2)
M6 screws (4)
M4 hex wrench