Procedure For Tilting Down (Manual Tilt Models); Procedure For Tilting Down (Power Trim And Tilt Models) - Yamaha 40V Owner's Manual

Operation
tor could shake loose from the tilt
support and fall. If the motor cannot
be trailered in the normal running po-
sition, use an additional support de-
vice to secure it in the tilt position.
For more detailed information, see
page 65.
[ECM01641]
4. Models equipped with trim rods: Once
the outboard motor is supported with the
tilt support lever, press the power trim
and tilt switch "
trim rods. NOTICE: Make sure that the
trim rods retracts completely during
mooring. This protects the rods from
marine growth and corrosion, which
could damage the power trim and tilt
mechanism.
[ECM00252]
EMU34470
Procedure for tilting down (manual
tilt models)
1. Release the tilt lock lever.
62
ZMU03115
" (down) to retract the
ZMU03786
2. Hold the rear of the top cowling with one
hand, tilt the outboard motor up slightly
and pull out the tilt support knob or re-
turn the tilt support lever.
3. Slowly tilt the outboard motor down.
4. Place the tilt lock lever in the lock posi-
tion.
EMU33121
Procedure for tilting down (power
trim and tilt models)
1. Push the power trim and tilt switch "
(up) until the outboard motor is support-
ed by the tilt rod and the tilt support lever
becomes free.
2. Release the tilt support lever.
ZMU06644
ZMU03788
"