Install Top Cowling; Power Trim And Tilt System - Yamaha 40V Owner's Manual

Operation
should supply oil normally. If no oil is
flowing after 10 minutes of idling, consult
your Yamaha dealer.
ECM00130
NOTICE
Be sure to take the above steps when op-
erating the engine after a long period of
storage. Otherwise engine seizure could
occur.
EMU36954

Install top cowling

1. Be sure that the cowling lock lever is re-
leased.
2. Be sure that the rubber seal is seated all
the way around the top cowling.
3. Place the top cowling on the bottom
cowling.
4. Check to be sure the rubber seal is seat-
ed correctly between the top cowling
and the bottom cowling.
5. Move the lever to lock the cowling as
shown. NOTICE: If the top cowling is
not installed correctly, water spray
under the top cowling can damage
the engine, or the top cowling can
blow off at high speeds.
42
After installing, check the fitting of the top
cowling by pushing it with both hands. If the
ZMU03367
top cowling is loose, have it repaired by your
Yamaha dealer.
EMU34581

Power trim and tilt system

EWM01930
●
●
●
[ECM01991]
1.
WARNING
Never get under the lower unit while it
is tilted, even when the tilt support lever
is locked. Severe injury could occur if
the outboard motor accidentally falls.
Body parts can be crushed between the
motor and the clamp bracket when the
motor is trimmed or tilted.
Be sure no one is near the outboard
motor before performing this check.
Check the power trim and tilt unit for any
sign of oil leaks.
ZMU06109
ZMU04678