Cleaning And Maintenance; Electrical Safety - Black & Decker NV1200AV Dustbuster Original Instructions Manual

ENGLISH
Injuries caused by touching any hot
u
parts.
Injuries caused when changing any
u
parts or accessories.
Injuries caused by prolonged use of
u
the appliance. When using any appli-
ance for prolonged periods ensure you
take regular breaks.

Electrical safety

The appliance is designed for use with
12V negative ground vehicle battery
systems.
Warning! The cigarette lighter connec-
fuse. The fuse may operate in the event
of a fault. If this occurs the fuse must be
replaced together with the connector and
cable by the manufacturer or an author-
ised Black and Decker Service Centre in
order to avoid a hazard.
Warning! Do not operate the appliance
with systems which have positive ground
or a different voltage.
Features
This appliance includes some or all of the following features.
1. On / Off switch
2. Release button
3. Dust bowl
4. Cigarette lighter connector
5. Brush tool
6. Small Crevice tool
7. Large Crevice tool
8. Hose
9. Right angle brush
10. Hose connector
11. Filter
Assembly
To fit an accessory proceed as follows:
Insert the appropriate accessory into the front of the
u
appliance
4
(Original instructions)
Use
Connecting to the vehicle's power
supply
Make sure that the appliance is switched off.
u
Remove the cigarette lighter from it's socket.
u
Plug the connector (4) into the cigarette lighter socket.
u
To switch on, slide the on/off switch (1) forward.
u
To switch off, slide the on/off switch (1) backward
u
The appliance can be used for periods of up to 30 minutes
without noticeably affecting the power of a normally charged
car battery in good condition.
Warning! Extended use will drain the battery power. Do not
run the vehicle's engine while cleaning as this can shorten the
life of the appliance.

Cleaning and maintenance

Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper care
and regular cleaning.
Press the release button (2) and remove the dust bowl (3).
u
Empty the dust bowl.
u
Remove the pre-filter (11) by twisting clockwise.
u
u
washed if necessary. Do not immerse the appliance in
water.
u
Refit the filters (11) onto the appliance twisting them coun-
u
terclockwise until they lock into place.
u
bowl clicks into place.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.
Warning! Never use the appliance without the filters.
Optimum dust collection will only be achieved with clean filters
and an empty dust bowl.
your BLACK+DECKER dealer (cat. no FLVD10):
Remove the old filters as described above.
u
Fit the new filters as described above.
u
-