Built-In Diagnostics - Dell P4317Q User Manual

Dell P4317Q
NOTE: This box also appears during normal system operation, if the video cable
is disconnected or damaged.
4. Turn off your monitor and reconnect the video cable; then turn on both your
computer and the monitor.
If your monitor remains dark after you reconnect the cables, check your video
controller and computer, because your monitor is functioning properly.

Built-in diagnostics

Your monitor has a built-in diagnostic tool that helps you determine if any screen
abnormality you experience is an inherent problem with your monitor, or with your
computer and video card.
NOTE: You can run the built-in diagnostics only when the video cable is
unplugged and the monitor is in self-test mode.
1 2
To run the built-in diagnostics:
1. Ensure that the screen is clean (no dust particles on the surface of the screen).
2. Unplug the video cable(s) from the back of the computer or monitor. The
monitor then goes into the self-test mode.
3. Press and hold button 1 for 5 seconds. A gray screen appears.
4. Carefully inspect the screen for abnormalities.
5. Press button 1 on the front panel again. The color of the screen changes to red.
6. Inspect the display for any abnormalities.
7. Repeat steps 5 and 6 to inspect the display in green, blue, black, white and text
screens.
The test is complete when the text screen appears. To exit, press button 1 again.
If you do not detect any screen abnormalities upon using the built-in diagnostic tool,
the monitor is functioning properly. Check the video card and computer.
48
| Troubleshooting
No mDP Cable
?
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
3 4 5