Makita 6914D Instruction Manual page 9

If you charge
a
battery cartridge from
a
just-operated tool or
a
battery cartridge which has
been left in a location exposed to direct sunlight or heat for a long time, the charging light
may flash in red color. If this occurs, wait for a while. Charging will begin after the battery
cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge
from the high capacity battery charger.
If the charging light flashes alternately in green and red color, a problem exists and charg-
ing is not possible. The terminals on the charger or battery cartridge are clogged with
dust or the battery cartridge is worn out or damaged.
If you wish to charge two battery cartridge, allow 15 minutes between charging on the
high capacity battery charger.
ASSEMBLY
Installing or removing driver bit or drill bit
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit
Use only the driver bit or socket bit shown
in the figure. Do not use any other driver bit
or socket bit.
To install the bit, pull the sleeve in the direc-
tion of the arrow and insert the bit into the
sleeve as far as it will go. Then release the
sleeve to secure the bit. To remove the bit,
pull the sleeve in the direction of the arrow
and pull the bit out firmly.
1 1
m m
17116"l
d
9 mm
1318' I
I
Bit
Sleeve
NOTE:
If the bit is not inserted deep enough into the sleeve, the sleeve will not return
to
its
original position and the bit will not be secured. In this case, try re-inserting the bit accord-
ing to the instructions above.
9