General Operation; Channel Scan; Network Connection; Connecting To A Wired Network - TCL LED55E5700UDS Operation Manual

3d smart tv

Hide thumbs

Table Of Contents

Table of Contents

Channel Scan

Make sure that the television is switched on and follow all the steps in turn specified hereafter.

1. Press MENU on the remote control under ATV source.

2. Press the ◄/► to select TV Setting, then press OK to enter the submenu. Press

OK to enter.

• Auto Scan: Press ◄/► to select Auto Scan and press OK button to start channel search automatically.

Note: Depending on the number of channels you receive, it may take several minutes for the channel search to

finish. If you want to interrupt the process, press OK or

channels may not be stored in the order of standard channel list.

• Manual Scan: Press ◄/► to select Manual Scan and press OK button to enter. Select Start Freq, press OK to

edit the frequency. The same goes to End Freq, then select Start to begin manual channel scan. When Manual

scan started, the TV will search the channel from the start frequency and will exit after finding a channel.

• Fine Tune: If the picture is not clear you can fine tune the channel. Press ◄/► to select Fine Tune and press OK

to enter. Select Frequency and press OK, use ◄/► to edit the frequency until getting a better picture.

3. Press

to return.

Note: 1. For models with DTV, it only has Auto Scan and Manual Scan to tune the TV, please refer to the above

steps and follow the prompt on the screen. 2. Digital channels support DVB-T2 & DVB-T.

Network Connection

To access the internet, you must subscribe high speed broadband internet service from your internet service provider.

Your TV can be connected to your home network in two ways:

• Wired, using the RJ45 (LAN) connector on the back panel.

• Wireless, using the internal wireless or external wireless USB adapter and your home wireless network.

Note: Instructions below are just the usual ways to connect your TV to the wired or wireless network. The connection

method may be different depending on your actual network configuration. If you have any questions about your home

network, please refer to your ISP (Internet Service Provider).

Connecting to a wired network

To connect to a wired network:

1. Ensure you have:

• An ethernet cable long enough to reach your TV

• A router or modem with an available Ethernet port

• A high-speed internet connection

• An Ethernet (LAN) port on the back of the TV

2. Connect your ethernet cable to the router and to the

Ethernet port on the back of the TV.

3. Use the Network Settings to configure the TV.

Connecting to a wireless network

To connect to a wireless network

1. Ensure you have:

• A router broadcasting a high-speed wireless signal

• A high-speed internet connection

• A wireless USB Adapter (not need for a built-in

wireless connection).

2. Remember to connect your wireless USB Adapter to

your TV's USB port.